Jon
Members-
Content count
30 -
Joined
-
Last visited
Everything posted by Jon
-
Jon added a post in a topic Wings, metal leading edge or no
Thanks for the input, I found the information on adding metal. As I checked the thickness for the tab they were all over the place. I had replaced an aft rib where the tab was brokenn and it was .240 others were .220, .20 or just under. I am using .30 material so can not put it on both sides except for one or two tabs. I am forming an angle on the bottom of the full plate and will make a partial plate on the other side with the angle on top. The partial will go around the flalperon mounting plate. It will still support the weak point.
I will let you know it it works.
Jon
-
0
-
-
Jon added a post in a topic Wings, metal leading edge or no
Akflyer, I'm not sure what a thread is but sounds OK to me. How will I find this thread, will it be under the Avid Flyer General Hanger?
Jon
-
0
-
-
Jon added a post in a topic Wings, metal leading edge or no
Thanks for the input, I will go with no metal. The missing braces are for the inboard and outboard ribs from the corner of the rib (near the trailing edge) to the rear spar, about a 12" brace.
Has any one reinforced the wood rib flaperon tabs with metal? They seem to be a week point. I am considering laminating .030 Alum. on each side. They still fit the slot on the flaperon bracket as the tab seems to be thin.
This is my first Avid, I did start a Fly Baby some years ago but sold it when I thought I had a medical problem (it turned out I did not) and I was also moving from Idaho back to Colorado for retirement.
As it show I am new to the forum I have lots of question, do I need to open a new topic for each one?
Thanks Jon
-
0
-
-
Jon added a topic in Avid Flyer General Hangar
Wings, metal leading edge or noI purchased a unfinished Mark IV Heavy Haulerkit last year and it had the wings in pink but it was not well done. I wanted to see what was under the fabric to determine the condition of the construction. It had two broken flaperon tabs, a broken small rib, no varnish on the wood and a couple of missing small corner braces. The overeall construction was sound. The repaiars have been made. The leasing leading edge was not covered in metal. I am ready to recover the wings so the question is, metal or no metal. I asked C5Engineer and he said it was not needed but said to ask all of you for an opinion. The wing does have the 4 mini ribs between the primary ribs.
Thanks,
Jon
- 59 replies
- 10,307 views
-
Jon added a post in a topic Need help with something on the forum? Ask it here
I am new to the forum and I have questions I would like to see if the members could answer. I am building an Avid Mark IV Heavy Hauler. Is this where I post the questions?
Jon
-
0
-