Parting out Kitfox 2

[1avidflyer 1983]

Hi all,  I ended up with a rough shape Kitfox 2, and am going to part it out.  Looks like it was ground looped, and seat truss is bent.  Looks like it was repaired once and then fixed again, then bent again.  Not beyond hope for someone who can fit and weld tubing though.   Wings are pretty rough, rear spars are salvageable, and maybe one front spar.  Flaperons are a bit dinged up, but center tube isn't bent.  Could be used again.  Landing gear, 8" wheels, hydraulic brakes all appear to be fine.  Rudder pedals good, joysticks and cross tube plus mixer controls behind the seat seem fine as well. 582 motor mount, and back two pieces of cowl, plastic fuel tank, and turtle deck also there.  Anyone needing any of these parts can contact me with a private message for starters.  If you want pictures of anything in particular, say the word.  Thanks,  JImChuk

PS  forgot to mention lift struts as well.  Here are a couple of pictues.  

Edited 25 Apr 2023 by 1avidflyer

[whizzers 35]

Interested in the control sticks and rudder pedals if available

717 363 7five five 2

 

Bob McCaa

 

[1avidflyer 1983]

Hi Bob,  the email address I got from you didn't work, so I just sent pictures and a message to you here in a private message.  Thanks,  JImChuk

[whizzers 35]

whizzers@verizon.net

 

[Taylor 0]

Do you happen to have a the rib that connects to the flapperon?

[mcsmarket 0]

Jim,

Do you still have this plane? 

Thanks.

[1avidflyer 1983]

Jim,

Do you still have this plane? 

Thanks.

I've still got a lot of parts to it.  JImChuk

[mcsmarket 0]

What's left if you don't mind letting me know?

 

[1avidflyer 1983]

Fuselage, seat, fuel tank, rudder pedals.   Joy stick and mixer controls behind the seat I think.   One landing gear, wings and flaperons (such as they are) lift struts.  Brake master cylinders and slave cylinders, and rotors, wheel hubs.  Aluminum rims are not in very good shape.   Send me a private message with your phone number and I'll give you a call if you like.  JImChuk

[mcsmarket 0]

Sent a message thanks.